Question Details

How do I login to the MAD Gateway?
How do I login to the MAD Gateway?
Show to public
Show in portal
Show to portal admins
Show to staff
Gateway, Network, Admin, Setup, Install, Login, Command Line, CLI
Release info on
6/4/2018 10:23:49 PM
Created on
6/4/2018 10:23:49 PM
Modified on
6/4/2018 10:23:49 PM

Edit | Back to List

Answer 1

Created On: 6/4/2018 10:25:58 PM Modified On: 6/4/2018 10:42:23 PM View this item  Edit this item  Delete this item
If you have the IP address of the gateway and a computer on the same network, you can login using the putty ssh client or similar software (credentials can be found below). You can obtain the IP address in multiple ways if using an ssh client is the preferred method of login. Please see the corresponding document in the QA section.

If this method is not available to you then you can log into the gateway directly.

Plug in keyboard via USB
Plug in Monitor via HDMI
Plug in network via CAT5/6 if available
Plug in power to the gateway and turn on the gateway if required (the gateway may not need to be turned on depending on button presence and power source.)

When presented with a login prompt use these credentials:
Username: mad
Password: mad

This will give you access to the Command Line Interface (CLI) of the MAD Gateway